Dry fly fishing is performed by means of flyline with trout flies that float, tied by a tapered leader, usually crafted from fine polyamide monofilament line though fluorocarbon can also be used. Fluorocarbon is a strong material that has no 'give' or stretch, this really is first-rate in smaller strengths for dry fishing flies. The tapered leader is 3 to five meters long, the thicker end tied towards the flyline and the thinner end is tied to your fly. It is normally virtually invisible where the fly is tied, normally if used for smaller trout a thickness of 0.12mm might be used. Ideally a tapered leader is non-reflective, on the other hand an angler can affix a length of a less reflective tippet material for the final 4 feet for connection with the fly. Unlike sinking flies (nymph) fly fishing, the "take" on dry flies is visible, explosive as well as exciting. Though trout normally devour roughly 90% of the diet from below-water sources, the ten% of surface consumption by trout is more than sufficient to keep most fly anglers hard at it. Additionally, new fly fishermen commonly favor dry fly fishing because of the relative ease of detecting a strike and the instant enjoyment of watching a trout strike their fly. Nymph fly fishing could possibly be more productive, but dry fly fishermen before long become addicted to the surface strike.
Dry flies can be "attractors", for instance the Royal Wulff, or "natural imitators", like the elk hair caddis, a standard caddisfly imitation. A beginner may need to begin with a fly that is simple to see for example a Royal Wulff attractor or perhaps a mayfly imitation such as a Parachute Adams. The "parachute" from the Parachute Adams makes the fly land as softly like a natural on the water plus has the added benefit of making the fly very noticeable on the surface. The fly ought to land quietly, as if dropped onto the water, with the leader completely extended from the line. As a result of rivers developing faster along with slower currents habitually running side by side, the trout flies can over take or be overtaken by the fly line as a consequence disturbing the fly's drift. Mending is a method where one lifts and moves the a part of the fly line that requires re-aligning with the fly's drift, therefore extending the drag free drift. The mend might be upstream or down stream subject to the currents carrying the line or fishing flies. To be effective, any mending of the fly line should not disturb the usual drift of the flies. Learning to mend is usually much simpler if the angler is able to see the fly.
Once a trout has been caught and landed, the fly may perhaps no longer float well. A fly can at times be dried and made to float again by "false" casting, casting the fly forwards and backwards in the air. In some cases, the fly is usually dried with a small piece of reusable absorbent towel, like a Amadou patch or chamois, or placed and shaken inside a container full of fly "dressing"; a hydrophobic solution like Semperfli's Desert Dust which dries a fly completely.
Once the fly fisherman has learned the techiques of casting plus mending a line then focus upon matching the hatch, using dry flies that accurately matches the natural flies hatching will become key to sucess.
Author Resource:
Andy is Director of www.theessentialfly.com, a quality manufacturer of fly fishing salmon flies & tackle. We have a large range of trout flies from buzzers, nymphs, lures to trout dry flies, fly fishing gear including rods and a large range of fly tying supplies from vises to natural and synthetic materials. Andy is a keen fisherman and constantly looking at new fly tying materials and fly fishing flies and their effects on the quarry fish.
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")