Do it yourself projects should be doable, easy and ultimately useful. The following are some practical DIY tasks that you can try if you have free time at home.
Wiring a plug
Wiring a plug only requires basic know how to carry out. First off, why would it be necessary to wire a plug? Sometimes, appliances’ plugs become brittle, and break. It is dangerous to use broken plugs. Broken plugs can result in electrocution and in some rare instances, death.
In some cases, the wires inside the plug becomes disconnected. The first thing to do is to unplug the device to be repaired from the power source. With a screw driver, remove the cover of the plug and proceed to clear the terminals of any dirt.
This applies to new plugs. The only difference would be the insides of new plugs are clean. Proceed to separate the three distinct wires. The neutral wire, the earth wire and the live wire. All three are important, don’t leave anything behind.
Attach the three distinct wires to the proper terminals inside the plug. Most plugs are uniformly built, so you won’t have any trouble carrying this step out.
The brown wire, which is the live wire should go to the portion of the plug marked “L”. The neutral wire, which is often coated with blue plastic should go to the “N” terminal. The third wire, the earth wire goes to the topmost region of the plug.
The copper wires should be wound around the proper terminals, or they should at least pass through. Some plugs require wounding while others do not.
Be careful with the fine strands of copper wire. Any loose strands should be fixed. Remember, loose strands can cause fire from shorts once you plug in the appliance.
Fixing a leaking faucet
You do not need a plumber to fix a leaking faucet. Often, leaking faucets can easily be remedied with the right tools. The first step to fixing a leaking faucet would be to turn off the water valve.
Leaky faucets are often due to brittle or broken rubber washers. These rubber washers are simple enough to be installed by anyone. Unscrew the top of the faucet after the water supply has been turned off.
Remove the broken washer and inspect the area. Clean the top portion of the washer of any kind of dirt. Molds should be removed with a clean sponge.
Place the washer and proceed to re install the handle of the faucet. If all goes well, you would be able to screw the handle quickly. If the washer’s size is right, the leaks would no longer appear. Turn off the water supply once again and test. A clean stream of water should appear.
In case this approach does not work, there is a possibility that there might be cracks or fissures on the faucet itself. Turn off the water supply once again, and inspect the faucet for minute cracks.
If there are minute cracks, purchase generic sealants. The sealants do not have to be expensive. Sealants like Epoxy Steel can be used.
Author Resource:
The author of this article is Benedict Yossarian. Benedict recommends Roof Bond Foam Roof Insulation and Dekorbeton Concrete Stamping for your DIY needs http://www.roofbond.biz/ http://www.dekorbeton.com/
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")