Let's talk about broken glass in a fixed window, usually referred to as a picture window. The most typical kind will have metal stops on the outdoors, about all 4 edges from the window glass. Sometimes these stops will probably be held in location with screws, as well as other times there will be aluminum stops that snap in location. In some rare situations there will probably be a rubber material in place of metal. If you have the screw type, you eliminate all of the screws and each piece will come out. When you have the metal snap in stops, carefully pry the stop in the frame using a little, flat screwdriver or perhaps a putty knife. You would like to begin in a corner and work along the stop until it comes out. Don't pry too a lot since the stops can bend extremely effortlessly. If you have the rubber type, pry a corner away using the screwdriver, grab it together with your fingers, and pull out the rubber. The glass shouldn't fall out simply because there's a glue or tape around the edge, holding the glass in place.
From right here, You are able to get your measurements for the new piece of glass. The glass edges will be exposed, and you can hook your tape measure towards the edge and get your width and height. If there is a hole in the glass, measure the glass thickness. If there is not a hole, put on some gloves and carefully push around the glass where the crack is situated. This will expose the edge so you can measure it. Whenever you go to get the new glass, you are going to require a tube of silicone to replace the glue or tape holding the glass in location. As soon as you get the glass home, you have to remove the old glass. Go inside and cut in between the glass and frame using an utility knife having a new blade. This may cut away the silicone or tape that's holding the old glass. Be sure to put on heavy gloves throughout this process to avoid obtaining cut. Start at the top and reduce across from 1 corner towards the other. Then reduce down one side, from top to bottom. Do the other side exactly the same way. At this point the glass ought to fall out. You should location a tarp or sheet below the window to catch the glass because it falls out. Utilizing a stiff putty knife, scrape off the old silicone or tape from the frame. If there had been setting blocks on the bottom, make sure to reuse them. They act as shims to raise the glass off the bottom.
Now run a bead of silicone about 3/16" thick around the perimeter of the opening. Grab your new glass around the sides, angle the bottom in and also the top out, set the glass around the setting blocks, then gradually raise the glass up into place. Push just hard sufficient that all four edges from the glass get in touch with the silicone, but not so hard that the glass makes contact using the metal frame. Install your outdoors stops. Don't clean the glass for 24 hours so the silicone can setup.
Author Resource:
A lot of people check out our upvc repairs Dublin website to discover a lot more information about window doctor Romford .
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")