In this how one can information I will be showing you the way create a wireless bridge between a Linksys 160n wireless router and a Linksys WRT54GS wireless router that has been modded with the DD-WRT firmware. You might ask your self what's a wireless bridge.You also may ask your self why you'll want to create a wireless bridge within the first place. Well a wi-fi bridge is while you join one router to another router without utilizing any exhausting wired cables. You might wish to create a wireless bridge for some of the following reasons.
Laptop are positioned at completely different ends of your house and you cannot run a ethernet cable between the 2 router. You wish to hyperlink to you neighbors community so you may share web service, information, and media similar to music and movies. The possibilities are limitless on the subject of networking routers collectively utilizing wireless.
For the wireless bridge setup I shall be utilizing the following ip deal with and subnet setup:
The Linksys WRT 160n wi-fi router will probably be straight connected to the Internet service, and the Linksys WRT54GS DD-WRT modded router will create the wi-fi hyperlink between the 2 routers. One of the best ways to setup your wireless bridge is to have a computer that has both a wifi connection and a ethernet connection. To start the installation, use your wi-fi connection to hook up with router 1, which is the Linksys WRT160N. After you might have connected the router, open your net browser and kind in the default gateway which must be 192.168.1.1. Click on the Status Tab and make sure that router 1 has a web connection.
After you realize that the primary router has a internet connection, go to the Wireless Security Tab and setup the encryption kind and paraphrase key. Make sure that you are utilizing compatible encryption between both of the routers.linksys-wrt160n-wpa-wi-fi-safety
After you've set the encryption kind and key on the first router, disconnect from this router. Now connect with the WRT54GS DD-WRT modded router, then go to the setup tab and change the native network to 10.0.1.0 or no matter community range you prefer.
* Local Ip Address: 10.0.1.1
* Subnet Mask: 255.255.255.0
* Gateway: 10.0.1.1
* Local Dns: 10.0.1.1
After you may have changed the network setup on your modded DD-WRT router, disconnect from the router then reconnect to so that you just receive your new ip address. Your new ip tackle ought to be someplace within the 10.0.1.zero network. Now open an internet browser at level it in direction of 10.0.1.1, which is now the default gateway in your WRT54GS DD-WRT modded router.
Now go to the standing tab and click on on the wireless tab. Inside the wi-fi tab you need to see a button that says web site survey. The site survey button is situated in the direction of the bottom of the page. All you need to do now is select router 1 from the checklist, which must be the Linksys WRT160N.
After you have selected router 1 from the listing, go to the wireless tab and click on the wireless security tab. All you need to do now could be input the exact same encryption kind and key that you setup for router 1. After you might have set the encryption type and key into ybur modded DD-WRT router, all you have to do is apply the settings. It is best to now have a wi-fi link between the Linksys WRT160N and the Linksys WRT54GS. Now connect using a wi-fi connection to the DD-WRT modded router, and ensure your internet connection work.
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")