When hanging something on a wall, whether it is a shelf, curtain pole, picture or flowering basket, you need a strong fixing to ensure the item stays attached. At all times check for hidden pipes and electric cables with an electronic detector before drilling into your wall. Listed here are a couple of examples.
Putting up a fixed shelf.
The simplest shelf supports are non-adjustable brackets, which are ideal for putting up an individual shelf. Space the brackets according to the shelf material, its thickness and the load the shelf will probably be supporting. Brackets are fitted with the longer arm against the wall and the shorter one under the shelf, therefore the length of the longer arm will determine how closely shelves may be fitted one above another in case you need to put up multiple shelving.
1. Hold the shelf against the wall and mark where you wish the bottom to go. Then mark where the first bracket is required to be, along with the space to the next bracket. Check the marks are level using a spirit level.
2. Hold the initial bracket up to your mark, checking it is vertical, and mark the wall inside the fixing holes. Repeat with the second bracket. If there's more than two brackets, fit them between the outer brackets, equal distances apart.
3. Drill into the wall, insert wallplugs if you have a masonry wall, and screw the brackets in place. Lay the shelf across, and put a mark through the holes in the brackets for the fixing screws underneath it. Take the shelf down and drill pilot holes for the short screws, but ensure not to go all the way through the shelf. Replace the shelf and screw home the fixing screws.
Putting up a curtain track.
When putting up a curtain track or even a pole, either buy the right length or get one longer than you require and cut it to fit. The screws supplied with the curtain track might not be long enough to attain a secure fixing. In that case, use longer screws and wallplugs, or screw into sound ceiling timber. The window top or ceiling might not be quite level, so mount the track parallel to whichever is the most horizontal.
1. Decide on the correct length of track to match your curtains and cut it to length using a fine-tooth hacksaw. Remove any burrs from your cut ends using a craft knife or file. If the window is wide and the curtains thick, the track will have to reach further than if the fabric is lightweight. Calculate how much the track will reach beyond the recess. Use a ruler and pencil to extend the top line.
2. Measure 25mm in from your end of the line and 50mm up; this is exactly the fixing position for the end bracket. Repeat to discover the position of the other end bracket. Mark the remaining fixing positions at equal intervals between the two end brackets, measuring 50mm up at the top of the window recess each time
3. Check at each fixing position that you have no hidden pipes or cables. If all is clear, drill the fixing holes and insert wallplugs of the right size for the screws. Screw the mounting clips into position, following the manufacturer’s instructions. The bracket latches that the track fits into needs to be facing forward.
4. To fit the end stops, slip one over each end of the track and tighten the retaining screws.
5. Place the track into the slot in the end brackets. Push the bracket latch until you hear a click. Clip the remaining track into place in the same way.
Author Resource:
Believe me when I say that I understand how hard it can be to do these tasks that I have written about in this article. I have applied these tips to many painting projects through the years but from the beginning when I first began in the painting trade there was a good deal to learn. For my training I went to an organization called - painter london - They taught me everything that I know these days.
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")