Light emitting diodes or LED lights are extremely popular, so they are easily obtainable on the market. There are various different views concerning the efficiency in comparison to fluorescent lights. Many people state that these lights are more efficient than the fluorescent lights, whilst others refute this. Continue reading if you wish to learn about these types of lights and how to use the 12 volt led lights and more.
LED lights may be made of one or more of such bulbs. That is the reason LED bulbs last a lot longer than any standard bulbs. Not only do these lights last longer, they in addition do not consume much power. LED lights have a drawback. Though they can be used for numerous purposes, currently, most of LEDs available are designed for lights that receive supply under 12 Volts. This is the reason the 12 volt LED lights deserve a special mention.
12 Volt LED lighting is good lighting. The most common application of such a lighting is in automobile. Identifying the number of LEDs could be linked to the 12 Volt supply can be quite tough. LEDs are offered in packages that mention relevant specs.
When experimenting with LED lights, you will notice that it is not difficult to work with a soldering iron to connect the lights to see how they work. In case you're not aware of the various features, unless they are 1W or even 3V super bright Luxeon clones or LEDs, the LED lights will sometimes have voltage needs of 2.5 - 3 volt. Generally, the voltage requirement to get full brightness is normally around 30 milliamps.
After that, you could estimate the amount of LED series you're able to place on a single string, as well as the value for current limiting resistor. These will equally be determined by the input current and the components of the LED lights. You can use a theoretical approach or possibly a more practical experimental technique.
By using a theoretical technique, begin with the forward voltage and the current specs to get full LED illumination. As an example for 12 volt LED lights minimum input you can use 3 volt LEDs. This existing limiting resistance value will be comparable to 12 - 9 volts; 0.03 Amps and equal to 100 ohms.
Using the experimental approach, start by assuming approximately 3 volt frontward voltage need and 30 milliamps per LED. When the voltage is divisible by 3, it's essential to utilize 1 less. As an example, for a 12 volt LED you can use 3 single string series and for the 24 volt, it is possible to use 7 single strings.
You are able to place many LED strings in parallel given that each string possesses its own resistance, which is established for that string. Because of this, you will get strings with various amounts of LED's, offered that you are using the correct LED on each string.
Final factor to think about:
While using solar power, the voltage selection can be substantial. When it comes to 12 volt LED lights with equalized batteries, the voltage can be a little above 15 volts. Remember that whenever the lights are running the voltage will be different, other than in cases where additional sources besides the solar panels might be charging.
Be sure that you do a research to figure out which lights to operate at home, for example whether the white led lights will be more efficient than others.
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")