Video cards are very susceptible to static electricity. Make sure that you ground yourself before working with them, if you want to be extra safe wear latex gloves. Video cards are also very delicate, so make sure you handled them with care, hold them only by the edges and make sure you don't bend them.
You're going to start out with the expected steps of turning off your PC, unplugging it and then removing the case. Then you going to locate the correct spot to plug in your video card, you did the PCI express 16 X slot or the APG slot, the card won't go into the incorrect plot. See can really make a mistake here . Just make sure that you don't confuse the computer's memory slots for its video card slots. Nine going to take a small screwdriver and remove the screw holding the whole card or metal cover, make sure you hold and the screw, you're going to need it to secure the new card in place, now you're going to take your old card and pull it up and out. Now, once you know which slot you are supposed to the card in, you're going to hold the card by its edges and place it over the correct spot, the edge of the metal bracket should face towards the back of your computer. Now you're going to wind up the tab and notches on the bottom of the card with the notches in the slot. Push the cards slowly into the slot, you may need to rock it back and forth gently, once the card popped that you should feel it, make sure you don't force it. Now all you have to do is secure the card into the slot with the screw that you removed earlier and then put the cover back on.
Author Resource:
Ben has been writing articles for quite a bit of time now, and while the writing may be sloppy, the information is sure to be accurate, he also makes websites about things like Wap Vacuum Cleaners and Volta Vacuum Cleaners