On a RC car that has a 2 speed gear box, the larger gear wheel could have an one way bearing within the middle which assists the gearbox and spins in one route by sitting on the gearbox however won't spin in the reverse direction.
If the air or area is chilly and or dirty then chances are you'll find that the one way bearing could fail because of the great changing into cold or dirty so looses its liquidity which means the bearing to slip. If so then try and warm up the car and gearbox for five to 10 minutes by means of a small heater, hairdryer and you need to find the problem goes away.
If the issue reoccurs then the primary gear wheel will should be eliminated and wd40 or related utilized to the bearing and shaft. Utilizing the wd40 make sure that the shaft and the centre of the one way bearing take away all grease. You possibly can then apply contemporary grease however ensuring it's one way bearing grease. You can find that remove the RC cars gearbox is fairly simple but will take just a little while.
To distant the gearbox, find the 4 screws beneath the chassis and distant them after which remote the screws which maintain the top chassis on. The servo cable might be connected so that you won't be able to take away the higher chassis but it may be moved out the way in which enough. You may then access the gearbox and put back in happy with sufficient clearway. To put the drive shafts back into the drive cups could be tedious but discover some tools comparable to pliers to keep them out the way. After you have cleaned the bearing, if it slips nonetheless then chances are you'll need to exchange it.
Another explanation why your rc automotive won't move such as -
If the brake pads are touching or to tight can cause It not to move. Also if the car has been by means of water and the brakes are moist they could of expanded which stops the breaks from disengaging. You'll A grub screw may of come free which is normally connected to the drive cups, this allows the drive cup to go round so stopping the drift shaft from turning and shifting the car.
A component or components inside the differentials could of snapped or not tight enough. This area means you will want to open up the differentials and give a visual inspection to see if anything appears wrong. Have a look at the cogs, possibly they're slipping or worn out. If they are worn then they should get replaced instead of making an attempt to fix them up and transfer them together more.
Author Resource:
For supplementary information on RC cars visit our website!
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")