Pick the location for your second story deck based on obstacles at ground level, handy access, and second story entrances. Your location will also decide the dimensions of the deck itself, so take measurements of the length and width of the chosen region after which design your deck frame about these dimensions.
two
Layout the length and width dimensions subsequent to the residence inside the location of the future deck and mark the 4 corners and the midpoint of each side. These will probably be the locations of your 6 inch by 6 inch support posts. Use the auger to drill four foot deep holes in which to slip the bottom of the 6 inch by 6 inch posts. It really is up to you how high your deck extends onto the second story, nonetheless a typical height is 8-9 feet. Fill each and every hole partway up with DRY Quikrete concrete mix after which drop the posts in permitting the desired height level of support post extend above ground level. Use a level to make sure every post is plumb after which fill in about the posts with soil along with the remaining concrete. Let this setup for a minimum of 24 hours prior to working on the posts.
three
Build the frame of the deck on the ground by bolting 4 boards into a square or rectangle the size of the projected deck. Install crosspieces all through the frame each and every two feet to insure a powerful base on which to lay your flooring. Using volunteers or a small crane, hoist the boxed in frame on top of your support posts and attach by screwing the lag screws through the frame into the support posts.
four
Construct the deck flooring by laying down the treated decking boards parallel to 1 yet another on best of the elevated box frame and screwing down tight using the wood screws. Install the railing kit based on the manufacturer's instructions and determine where a staircase are going to be installed. Leave the region for the staircase cost-free of railing.
five
Buy two staircase runners of the suitable height and size for your deck application. Use lag screws to mount the runners towards the deck and let the bottom portion of the runners sit on a concrete pad on the ground. Cut left over decking boards into steps for your staircase and mount the actions using wood screws. Begin entertaining!
Author Resource:
This article has been written and researched by Paul Henderson, working inconjunction with the top Fencing London contractors. Fences and Decking.com working in London, Surrey and Sussex, RH10 5NJ, 01293278112.
![[Valid RSS feed]](http://www.look4articles.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites
![[Valid RSS feed]](http://www.look4articles.com/images/rss.jpg "XML Feed For RSS")